NorthWest_Polycarbonate
Bronze Polycarbonate Snap Profile for 8mm Sheets, 16 ft.
Bronze Polycarbonate Snap Profile for 8mm Sheets, 16 ft.
Couldn't load pickup availability
Bronze snap profile for 8 mm twin wall polycarbonate, 16 ft, for our 4x16 sheets. The base screws down, the cap clips over the seam and hides the screws.
Specification:
Type: Snap profile
Length: 192 in.
Color: Bronze
Connect your polycarbonate panels quickly and with confidence using our Snap Profile – designed for easy installation, a clean finish, and 100% waterproof performance.
No more struggling with complicated connectors. This user-friendly, two-part system makes your project fast and efficient:
- Screw the bottom part directly onto your rafters
- Place the panels in position
- Snap the top part on – and you're done!
Goes together with
- Bronze 8 mm twin wall sheet, 4x16 ft of the same length, so the seam has no cross joint.
- Roofing screws with neoprene washer, the profile screws down to the rafter before the cap clips on.
- U channel end cap and aluminum tape to close the open ends of the sheets.
One profile per seam plus one for each outer edge. The buyer's guide works the count out by project, and the installation manual shows the fitting order. Full range: connectors and roof panels for pergolas and patios.
Share
Delivery and pickup
Delivery from $130 across the Seattle metro area, Saturdays. Free pickup at our Kent warehouse, 27000 Pacific Hwy S, by appointment. One flat rate per order, any quantity. Zones and prices are on our Shipping Policy page.